• Support Center
• Guarantee
• Installation
• Configuration Sample
• FAQ's
• Requirements

Linksys/Sipura

How to know your ATA`s current IP address?

 

Plug in your ATA for power. Connect your telephone set with the ata’s Line 1 (or Line 2 if Line 1 is already in use with another provider):

1. Now You need to enter the IVR menu of your ata. Press **** (4 times). You will hear “Sipura configuration menu. Please enter option followed by the pound key or hangup to exit.”
2. After hearing the message press ‘110#’, IVR will announce the current ip address of adapter.
3. Incase the ip address is 0.0.0.0 you need to set the ip address of your adapter.
4. To set the ip address of your ata press “111#” after pressing **** for main IVR menu. And then enter ip address using numbers on the keypad of your phone. Use a * (star) key when entering a decimal.
5. Also set the Network Mask by dialing ‘121#’.
6. Set the Default Gateway using ‘131#’.

How to configure the line settings?
 

Open the web browser on your computer and type the ip address of your adapter in the url. Go to voice settings and click on Line1. You should see a page similar to the screenshot below. Fill in the required fields as described.

 

 

      
      
Click on the mentioned link for admin login. After clicking on it you need to click on the “voice” tab to see the voice settings
      

       

 

Voice tab appears like this:
 

 

    
Click on line1 as mentioned in the figure.

 

   
    

 All the settings you see in the above screen you should enter in your ata as it is except the following

1. Display Name: enter your CallerID.
2. User ID: Enter your username here.
3. Password: Enter password here.
4. Auth ID: Enter username again here

Incase you cant read the proxy in the picture, here its is: magnum.axvoice.com:9060
After typing all the fields you press the “Submit All Changes”.       
      
After submitting the changes you will see the following page for a few seconds and then the main screen will appear which will show the registration status of your spa.

       
      

      
And then …

 

       
      
      
 

If the registration state shows “Not Registered” then wait for few seconds and then refresh the page, it will change the registration state to “Registered”. If it still shows “Not Registered” then you may have entered the credentials incorrectly. Go back to line1 settings and re-enter the credentials.

 

If the registration state shows “Not Registered” then wait for few seconds and then refresh the page, it will change the registration state to “Registered”. If it still shows “Not Registered” then you may have entered the credentials incorrectly. Go back to line1 settings and re-enter the credentials.