Trixbox - Creating Outbound Sip Route

---

1. Login to the admin interface of  FreePBX. To be able to send outgoing calls to Axvoice server you have to do two main steps:
   
   Create a trunk
   Create an outbound route
    
2. Click on “Add SIP Trunk” to cerate a SIP trunk, as shown below:
   
   
   
   Click on “Add SIP Trunk” to cerate a SIP trunk, as shown below:
   
   
    
3. On the next screen set the maximum simultaneous outgoing channels in the “General Section” and also add the following dialing rules in the “Outgoing Dial Rules” section, as shown in the screen shot below:
   
   DIAL RULES
   
   NXXXXXX
   NXXXXXXXXX
   1NXXXXXXXXX
   011.
   9000
   9001
   911
   
   
   
    
4. Scroll down to “Outgoing Settings” section and add the following trunk name and peer details:
   
   TRUNK NAME: to-axvoice
   PEER DETAILS:
   
       
   Host=magnum.axvoice.com
   Port=9060
   Type=peer
   Qualify=no
   Insecure=port
   Disallow=all
   Allow=alaw&ulaw&gsm&g729
       
   Remove g729 codec from the list of allowed codecs here if you do not have this codec installed on your machine.
       
   Add the above given details as shown below in the screen shot:
             
   
   
    
5. Scroll down at the end of the page and add the registration string according to the following syntax in the “Registration” section. Leave the incoming setting blank here.
   
   Registration Setting
   Axvoice-username:password@magnum.axvoice.com:9060    
   Add this setting as shown below and click submit button to save changes in the screen shot:
   
   
    
6. Do not apply changes to make the changes permanent yet. You will see on the right side of the screen that your trunk has been saved.
   
   
    
7. Do not apply changes to make the changes permanent yet. You will see on the right side of the screen that your trunk has been saved.
   
   
    
8. In the “Add Route” page give the following details as shown in the screen shot:
   
   Route Name: to-axvoice
   Dial Pattern:
   NXXXXXX
   NXXXXXXXXX
   1NXXXXXXXXX
   011.
   9000
   9001
   911
   
   Trunk Sequence: (select your previously created trunk from the list of given trunks)
   Click submit to save changes.
   
   
    
9. Before proceeding check on the right side of the screen, that your route is saved. If there are any other routes present, delete them. To delete a route click on the route name. You will then see an option link on the top of the settings screen to delete that route. Click on it to delete the route.
   
   
    
10. Now click on “Apply Configuration Changes” to make the changes permanent. Now you will be able to make outgoing calls.